4-6 Service Manual
4097-00X
Mid Frame / Star Roller Assembly Removal
1. Remove the front cover.
2. Remove the carrier frame.
3. Remove the exit roller.
4. Remove the small feed roller assemblies.
5. Remove the EOF flag.
6. Depress the latches located on the rear of the mid frame and
remove the mid frame and star roller assembly.
Note: If any glue is present on the star roller assembly during
removal, replace the star roller assembly. Do not reinstall the old star
roller assembly.
Operator Panel Assembly Removal
1. Remove the front cover.
2. Remove the carrier frame.
3. Disconnect the operator panel cable from the system board.
Note the routing of the cable.
4. Remove the operator panel screw from the carrier frame.
5. Remove the operator panel.
Paper Feed Motor Removal
1. Remove the front cover.
2. Remove the carrier frame.
3. Disconnect the paper feed motor from the system board.
4. Remove the two screws mounting the paper feed motor to the
gear plate assembly and remove the motor. Note the routing of
all cables.
Paper Guide Removal
Slide the paper guide to the center of the printer, lift up and remove.