Change [paper source] to [paper type] [paper size] load [orientation]
Try one or more of the following:
•Load the correct size and type of paper in the tray or feeder, specify the paper size and type in the Paper menu on
the printer control panel, and then touch Finished changing paper.
•Touch Reset active bin to reset the active bin for a linked set of bins.
•Cancel the print job.
Check tray [x] connection
Try one or more of the following:
•Turn off the printer, and then turn it back on.
If the error occurs a second time, then:
1Turn off the printer.
2Unplug the power cord from the electrical outlet.
3Remove the indicated tray.
4Reattach the tray.
5Connect the power cord to a properly grounded electrical outlet.
6Turn the printer back on.
If the error occurs again, then:
1Turn off the printer.
2Unplug the power cord from the electrical outlet.
3Remove the tray.
4Contact customer support.
•From the printer control panel, touch Conti nue to clear the message and resume the job.
Close door or insert cartridge
The toner cartridge is missing or not installed properly. Insert the cartridge, and then close all doors and covers.
Close finisher rear door
Close the rear door of the finisher.
Close flatbed cover and load originals if restarting job [2yy.xx]
Try one or more of the following:
•Touch Scan from automatic feeder to continue scanning from the ADF immediately after the last successful scan
job.
•Touch Scan from flatbed to continue scanning from the scanner glass immedi ately after the last successful scan
job.
Troubleshooting 296