Custom Master TV Setup (Cont.)

Custom Master TV Setup Procedure

1.Turn ON the TV.

If the Express Script Installer Menu Wizard appears on the screen when you turn ON the TV, use the Up/Down arrow keys on the Installer Remote to select Exit Express Script, and press OK (Enter).

2.Set Installer Menu items.

This step provides specific instruction only on the Installer Menu items that should be set on a Master TV. Refer to pages 19 to 27 for detailed information on all Installer Menu items.

xxLQ630H PTC INSTALLER MENU

CPU-CTV

a)Use the Installer Remote to access the PTC Installer Menu (see “Accessing the Installer Menu” on page 19 for further information).

The next step depends on whether the Express Script Installer Menu Wizard appeared when you turned ON the TV:

If the wizard did appear, the TV is in a factory default state, and you can proceed to set Installer Menu items. Go to step (c).

If the wizard did not appear, go to step (b).

b)Set Installer Menu item 117 FACT DEFAULT to 1 and press OK (Enter) on the Installer Remote.

This clears all Installer Menu custom settings, channel lineup, etc. and restores the factory default settings. The value will change back to 0 after the PTC has been restored to factory default condition. This step ensures that the TV Channel Memory will be the active channel lineup.

c)Set Installer Menu item 003 BAND/AFC, as appropriate.

Broadcast: Set to 0.

HRC: Set to 2.

CATV: Set to 1 (default).

IRC: Set to 3.

000

INSTALLER SEQ

000

 

 

 

UPN

000-000-000-000

ASIC D279

PTC

V1.00.029

CPU V3.50.00

 

 

 

Typical Installer Menu

Note: The Installer Menu header will vary depending on the TV you are setting up.

117

FACT DEFAULT

000

003

BAND/AFC

001

027

HOSPITAL MODE

254

Adjust the values for these

Installer Menu items.

d)Set Installer Menu item 027 HOSPITAL MODE, as appropriate, to select the speaker configuration.

e)Set any other Installer Menu items that affect your TV programming network to the required configuration. For example, enable/disable Aux inputs, set a Start Channel, etc.

f)After you have adjusted all Installer Menu item settings as required, press OK (Enter) once on the Installer Remote to save your changes; then, press OK (Enter) again to exit the menu.

Note: If you performed step (b) above to restore factory defaults, the Express Script Installer Menu Wizard will re-activate as soon as you exit the Installer Menu. Exit the wizard (see step 1), and then continue with step 3.

3.Set up TV features.

On-screen setup menus control the features of the TV. Press MENU on the Installer Remote to access the TV setup menus, and then set Channel, Picture, Audio, Time, etc. options to the desired configurations. See “Clonable TV Setup Menu Features” list on previous page and also notes on the following page.

CHANNEL

PICTURE

AUDIO

TIME

LOCK

OPTION

INPUT

MY MEDIA

Use the TV setup menus to set the TV features to the desired configuration for the end user.

Audio Menu Note: Audio Menu options are inaccessible (grayed out) if TV Speaker is not selected (i.e., Pillow Only is selected).

(Continued on next page)

16

206-4207