LG Electronics 50PC1R

CONNECTIONS & SETUP

NOTE

To enjoy vivid picture and sound, connect a PC to

the set.

Avoid keeping a fixed image on the set’s screen for

a long period of time. The fixed image may

become permanently imprinted on the screen; use

a screen saver when possible.

Connect PC to the RGB (PC/DTV) or HDMI IN

port of the set; change the resolution output of

PC accordingly.

There might be noise according to some resolu-

tion, vertical pattern, contrast or brightness in PC

mode. Change the PC mode into another resolu-

tion or change the refresh rate into another rate

or adjust the brightness and contrast on the

menu until the picture is clean. If the refresh rate

of the PC graphic card can not be changed,

change the PC graphic card or consult it to the

manufacturer of the PC graphic card.

The synchronization input waveform for

Horizontal and Vertical frequencies are separate.

In 42PC1R

50PC1R

50PC3R

models, we rec-

ommend using 1024x768, 60Hz for the PC mode,

they provide the best picture quality.

We recommend using 1360*768, 60Hz (32LC2R*,

37LC2R*, 42LC2R*,32LB1R*, 37LB1R*. 42LB1R*)

for the PC mode, they provide the best picture quality.

If the resolution of PC is over UXGA, there will be

no picture on the set.

Connect the signal cable from the monitor output

port of the PC to the RGB (PC/DTV) port of the

set or the signal cable from the HDMI output port

of the PC to the HDMI IN port on the set.

Connect the audio cable from the PC to the

Audio input on the set. (Audio cables are not

included with the set).

If using a sound card, adjust PC sound as required.

This set uses a VESA Plug and Play Solution. The

set provides EDID data to the PC system with a

DDC protocol. The PC adjusts automatically when

using this set.

DDC protocol is preset for RGB (Analog RGB),

HDMI (Digital RGB) mode.

If required, adjust the settings for Plug and Play

functionally.

If graphic card on the PC does not output analog

and digital RGB simultaneously, connect only one

of either RGB (PC/DTV) or HDMI IN to display

the PC on the set.

If graphic card on the PC does output analog and

digital RGB simultaneously, set the set to either

RGB or HDMI; (the other mode is set to Plug and

Play automatically by the set.)

DOS mode may not work depending on video

card if you use a HDMI to DVI cable.

When you use too long RGB-PC cable, there

might be a noise on the screen. We recommend

using under 5m of the cable. It provides the best

picture quality.

Ofrecido por www.electromanuales.com

Downloaded From TV-Manual.com Manuals