LG Electronics AS-H076PB/D/M/WL1, AS-H096PB/D/M/WL1

14 Room Air Conditioner

Installation

Fixing the Indoor Unit

• Drill the piping hole with a ø50mm hole core drill.

Drill the piping hole at either the right or the left with

the hole slightly slanted to the outdoor side.

Drill a Hole in the Wall

5-7mm

(0.2~0.3")

Indoor

WALL

Outdoor

Plastic anchors

INSTALLATION GUIDE MAP

10mm

INSTALLATION GU

INSTAIIATION GUIDE MAP

Plastic anchors

INSTALLATION GUIDE MAP

Hanger hole

(Rear side of

the product)

2. Make a hole with a diameter of 6mm and

depth of 30-35mm by piercing a screw

point.

3. Drive the fore plastic anchors into drilled

points.

4. Hang the hole of product at the upper

screws, and remove the map. (Falling

attention)

5. Check the fixed product with light power.

1. Attach an Installation guide map on the

desired surface.

6. Look at suited horizon by horizontal

meter on the horizontal setting line, and

fix lightly the map by adhesive tape.

Drill the pierted part as a diameter of 50mm

for connecting piping. (In case of piercing

rear surface)

First, Drive the two points of the upper

parts by screws. (Leave 10mm for hanging

the product)

9. Drive the lower parts after facing the hole

of product with plastic anchors, and fix

completely the upper screws.

10.

In case of nothing wrong, connect the

pipe and the wire. (Refer to installation

manual)

Horizontality

NSTALLATION GUIDE MAP