4 Plasma Monitor
Safety Instructions

CAUTION concerning the Power Cord :

Most appliances recommend they be connected to a dedicated circuit; that is, a single outlet circuit which
powers only that appliance and has no additional outlets or branch circuits. Check the specification page
of this owner's manual to be certain.
- This may cause a fire or an electric shock.
Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed
power cords, or damaged or cracked wire insulation are dangerous. Any of these conditions could result in elec-
tric shock or fire. Periodically examine the cord of your appliance, and if its appearance indicates damage or dete-
rioration, unplug it, discontinue use of the appliance, and have the cord replaced with an exact replacement part
by an authorized servicer.
Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, closed in a door,
or walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance.
Use a dedicated power cord. Do not modify or extend the power cord.
Do not install, remove, or reinstall the unit by yourself (customer).
For electrical work, contact the dealer, seller, a qualified electrician, or an Authorized Service Center. For installa-
tion, always contact the dealer or an Authorized Service Center.
Do not use if the power cord or plug is damaged, or socket is loose. Use a dedicated outlet for this appliance.
Do not over bend the power cord and do not place anything on the power cord. Do not install the monitor near any
sharp edge to avoid wire damage.

Safety instruction (MW-71PY10G only)

When the trim becomes dirty or stained, softly polish the surface.
When polishing the surface, use gentle pressure. Heavy pressure can damage or discolor the surface.
Clean the surface quickly and use gentle pressure. Heavy pressure can damage or discolor the surface.
Keep the alcohol and the used cleaning towel out of the reach of children.
Do not use anything to scrape or scratch at the surface of this unit, this will cause damage to the surface.
Use soft gloves while installing or removing this unit to prevent damaging the surface.
Safety Instructions continuedSafety Instructions continued