12. Slide one SHAFT COLLAR (30) over each shaft of the ROLLER PAD
BRACKET (11).
13. Attach the ROLLER PADS (31) to the ROLLER PAD BRACKET (11) using
two M10 X 35mm BOLTS (19) and two PLATES (27) as shown. Tighten
the BOLT securely.
14. Slide the SHAFT COLLARS (30) to meet the ROLLER PADS (31) and
secure the ROLLER PADS against the PLATES (27) by tightening the
SHAFT COLLAR set screws. Install the two ROLLER PAD CAPS (32).
15. Attach the SEAT PAD (33) to the SEAT FRAME (7) using two M10 X
35mm BOLTS (12) and two 3/8" SAE WASHERS (5) as shown. Tighten
the BOLTS securely.
16. Install the COUNTERWEIGHT (34) to the WORKARM (18) using two M10
X 25mm BOLTS (19) and two 3/8" SAE WASHERS (5) as shown. Tighten
the BOLT securely.
Lat Pulldown
Assembly Instructions