Lincoln CAN-F30 manual

Date:	6/1/2008	MSDS No.:	CAN-F30
Trade Name:	Lincolnweld	801
Sizes:	---
Supersedes:	11/1/07

M A T E R I A L S A F E T Y D A T A S H E E T

For Welding Consumables and Related Products

Conforms to Workplace Hazardous Materials Information System (WHMIS) Rev. November, 1988

Section I & II - Preparation and Product Information

The Lincoln Electric Company of Canada LP	Product Type:	Submerged Arc Flux
	Representative Classifications:	None
179 Wicksteed Avenue
Toronto, Ontario M4G 2B9 CANADA	Prepared by The Lincoln Electric Company, Cleveland, Ohio, USA
Phone: (416) 421-2600	(216) 481-8100, on the date shown above.

Section III - Hazardous Ingredients (1)

I M P O R T A N T !

This section covers the materials from which this product is manufactured. The fumes and gases produced during welding with the normal use of this product are covered by Section VII; see it for industrial hygiene information.

CAS Number shown is representative for the ingredients listed.

(1) The term “hazardous” in “Hazardous Ingredients” should be interpreted as a term required and defined in the Hazardous Products Act and does not necessarily imply the existence of any hazard.

Ingredients:	CAS No.	Wt. %	TLV	LD50	LC50 mg/m3
			mg/m3	(Route/Species)	(Route/Species)
Magnesite	1309-48-4	30-60	10	Not Available	Not Available
Aluminum oxide and/or Bauxite	1344-28-1	10-30	10	Not Available	Not Available
Mineral silicates	1332-58-7	10-30	5**	590 g/kg LDLo	Not Available
				(oral/rat) reproductive
Fluorides (as F)	7789-75-5	10-30	2.5	4250 mg/kg	Not Available
				(oral/rat)
Silicates and other binders	1344-09-8	5-10	10*	1153 mg/kg	Not Available
				(oral/rat)
Manganese and/or manganese alloys and compounds (as Mn)	7439-96-5	1-5	0.2	9 g/kg	2.3 LCLo
				(oral/rat)	(inhalation/human)
Silicon and/or silicon alloys and compounds (as Si)	7440-21-3	0.1-1	10*	Not Available	Not Available
Iron	7439-89-6	0.1-1	10*	Not Available	Not Available
Crystalline-Silica (cristobalite)	14464-46-1	0.1-1	#0.025**	10,000 mg/kg	Not Available
				(oral/rat)

Notes:

(*)Not listed. Nuisance value maximum is 10 milligrams per cubic meter. TLV value for iron oxide is 5 milligrams per cubic meter.

(**)As respirable dust. Value for respirable quartz is 0.05 milligrams per cubic meter.

(LDLo, LCLo) Lowest published toxic concentration.

(#)Crystalline silica (quartz) is on the IARC (International Agency for Research on Cancer) and NTP (National Toxicology Program) lists as posing a carcinogenic risk to humans.

Section IV - Physical Data

Physical data such as odor, vapor pressure, density, evaporation rate and freezing or boiling points are not listed as they are not applicable to this product and its use.

Section V - Hazard Data

Non Flammable; Welding arc and sparks can ignite combustibles and flammable products. See CSA W117.2 Section 9.7 as referenced in Section VIII. Product is inert, no special handling or spill procedures required.

Rev 9/07 (CONTINUED ON SIDE TWO)