THEORY OF OPERATION
E-9 E-9
POWER WAVE 655/R
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
THERMAL PROTECTION
Three normally closed (NC) thermostats protect the
machine from excessive operating temperatures.
These thermostats are wired in series and are con-
nected to the control board. One of the thermostats is
located on the heat sink of the output rectifier, one on
the DC bus, and one on the output choke. Excessive
temperatures may be caused by a lack of cooling air or
by operating the machine beyond its duty cycle or out-
put rating. If excessive operating temperatures should
occur, the thermostats will prevent output from the
machine. The yellow thermal light, located on the front
of the machine, will be illuminated. The thermostats
are self-resetting once the machine cools sufficiently. If
the thermostat shutdown was caused by excessive
output or duty cycle and the fan is operating normally,
the power switch may be left on and the reset should
occur within a 15-minute period. If the fan is not turn-
ing or the intake air louvers are obstructed, the power
must be removed from the machine and the fan condi-
tion or air obstruction corrected. On later production
machines (above code 10500) the cooling fan runs
only when necessary. The F.A.N. (fan as needed) sys-
tem is controlled by the Control Board via a solid state
relay.
PROTECTIVE CIRCUITS
Protective circuits are designed into the Power Wave
655/R to sense trouble and shut down the machine
before damage occurs to the machineʼs internal com-
ponents. Error Codes will be flashed out by the
Red/Green Status LED on the front panel and LEDʼs on
the Control Board to help identify the reason for the
shutdown. See the Troubleshooting Section for more
information regarding Error Codes. Fault codes can
also be seen by using the Diagnostic Software.
OVER CURRENT PROTECTION
If the average weld current exceeds 880 amps, the
peak current will be limited to 100 amps until the aver-
age current decreases to under 50 amps or the system
is re-triggered.
UNDER/OVER VOLTAGE
PROTECTION
A protective circuit is included on the Control Board to
monitor the voltage across the input capacitors. In the
event that a capacitor voltage is too high, too low, or
becomes unbalanced side-to-side, the protection cir-
cuit will de-energize the input contactor. Machine out-
put will be disabled, and the "soft start" mode will be
repeated. The protection circuit will prevent output if
any of the following circumstances occur.
1. Capacitor conditioning is required. (This may be
required if the machine has been off for a long peri-
od of time and is connected for high input voltage
operation.)
2. Voltage across a capacitor exceeds 467 volts. (This
could result from high line surges or improper input
voltage connections.)
3. Voltage across a capacitor is under 70 volts. (This
would be due to improper input voltage connec-
tions.)
4. Internal component damage.