INSTALLATION
A-3 A-3
POWER WAVE 655/R
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
state fan control relay, located on the back of the Control PC
board enclosure.
LIFTING
Lift the machine by the lift bail only. The lift bail is
designed to lift the power source only. Do not attempt
to lift the Power Wave with accessories attached to it.
STACKING
Power Wave machines can be stacked to a maximum
of 3 high.
The bottom machine must always be placed on a
firm, secure, level surface. There is a danger of
machines toppling over if this precaution is not
taken.
-------------------------------------------------------------
MACHINE GROUNDING
The frame of the welder must be grounded. A ground
terminal marked with the symbol is located inside
the reconnect/input access door for this purpose. See
your local and national electrical codes for proper
grounding methods.
HIGH FREQUENCY PROTECTION
Locate the Power Wave away from radio controlled
machinery.
The normal operation of the Power Wave may
adversely affect the operation of RF controlled
equipment, which may result in bodily injury or
damage to the equipment.
------------------------------------------------------------------------
SAFETY PRECAUTIONS
Read this entire installation section before you
start installation.
ELECTRIC SHOCK can kill.
• Only qualified personnel should
perform this installation.
• Turn the input power OFF at the
disconnect switch or fuse box
before working on this equip-
ment. Turn off the input power
to any other equipment con-
nected to the welding system at
the disconnect switch or fuse
box before working on the
equipment.
• Do not touch electrically hot parts.
• Always connect the Power Wave grounding lug
(located inside the reconnect input access door)
to a proper safety (Earth) ground.
-------------------------------------------------------------
SELECT SUITABLE LOCATION
Do not use Power Waves in outdoor environments. The
Power Wave power source should not be subjected to
falling water, nor should any parts of it be submerged in
water. Doing so may cause improper operation as well as
pose a safety hazard. The best practice is to keep the
machine in a dry, sheltered area.
Do not mount the PowerWave over combustible sur-
faces. Where there is a combustible surface directly
under stationary or fixed electrical equipment, that sur-
face shall be covered with a steel plate at least .060"
(1.6mm) thick, which shall extend not less than 5.90"
(150mm) beyond the equipment on all sides.
Place the welder where clean cooling air can freely cir-
culate in through the rear louvers and out through the
case sides and bottom. Dirt, dust, or any foreign mate-
rial that can be drawn into the welder should be kept at
a minimum. Do not use air filters on the air intake
because the air flow will be restricted. Failure to
observe these precautions can result in excessive
operating temperatures and nuisance shutdowns.
Machines above code 10500 are equipped with F.A.N.
(fan as needed) circuitry. The fan runs whenever the
output is enabled, whether under loaded or open circuit
conditions. The fan also runs for a period of time
(approximately 5 minutes) after the output is disabled,
to ensure all components are properly cooled.
If desired, the F.A.N. feature can be disabled (causing the fan
to run whenever the power source is on). To disable F.A.N.,
connect leads 444 and X3A together at the output of the solid
CAUTION
WARNING
CAUTION