Linear DF-41/EC manual

DF-41/EC

DF-42/EC

REMOTE

CONTROL

For Use With DF-16/EC

Security Console

Operation

Instructions

(760)438-7000 • FAX (760) 438-7043 www.linearcorp.com

3.TEST REMOTE CONTROL

PRESS ONCE TO ARM CONSOLE TO AWAY MODEPRESS AGAIN TO DISARM CONSOLE TO OFF MODEONE CHIRP FOR ARM

TWO CHIRPS FOR DISARM

ONEBUTTONREMOTEPRESS FOR HOME AUTOMATION ONPRESS AGAIN FOR H/A OFF

	ONE BING FOR H/A ON
	ONE BING FOR H/A OFF
TWO	NOTE: PRESSING BOTH BUTTONS FOR
BUTTON	5 SECONDS ON THE TWO BUTTON REMOTE
REMOTE	WILL SOUND THE EMERGENCY SIREN

6. REPLACING BATTERIES

1. REMOTE CONTROL DETAIL

	CONTROLS
ARMS &	HOME AUTOMATION
DISARMS	OUTPUT
CONSOLE	KEYCHAIN

TWO BUTTONREMOTE CONTROLONE BUTTON

REMOTE CONTROL

4. REPLACING BATTERIES

REMOVE TWOCASE SCREWSHOLD CASE TOGETHERAND FLIP OVERCAREFULLY

LIFT TOP OF

CASE OFFREPLACE THE REMOTE CONTROL BATTERIES WHENTHE UNIT ONLY WORKS CLOSE TO THE CONSOLE OR IFIT STOPS WORKING ALTOGETHER

7. REPLACING BATTERIES

2. PROGRAM REMOTE CONTROL INTO CONSOLE

START IN		SEND SIGNAL
OFF MODE		FROM REMOTE
ENTER YOUR	PRESS	ENTER AN
SECRET CODE	LEARN	UNUSED SENSOR
		NUMBER

LEARN BUTTON

1
PRESS BUTTON
TO SEND SIGNAL	HOLD OFF BUTTON
(EITHER BUTTON	FOR 3 SECONDS WHEN
ON TWO BUTTON	FINISHED TO EXIT
REMOTE)	LEARN MODE
5. REPLACING BATTERIES
CAREFULLY	WARNING:
CAREFULLY	HOLD BOARD BY
REMOVE THE	EDGES ONLY
CIRCUIT BOARD

BOARD

ALIGNMENT

POSTS NOTE BATTERYLOCATIONS

INTERNATIONAL WARRANTY

		WARNING: DO NOT
		INSTALL BATTERIES
	PLACE FRESH BATTERIES	BACKWARDS, UNIT
	PLACE FRESH BATTERIES	WILL BE DAMAGED!
	ON SPRING IN HOLDER	WILL BE DAMAGED!
	ON SPRING IN HOLDER

PLUS (+) SIDE UP

MINUS (-) SIDE UP

PLACE BOARD ON ALIGNMENT POSTS

SQUEEZE

CASE TOGETHER, FLIP OVER AND REPLACE SCREWS

CAUTION: DO NOT TOUCH OR ADJUST ANY PARTS ON BOARD

HOOK CASEHALVESTOGETHER

This Linear product is warranted against defects in material and workmanship for twelve (12) months. The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or liabilities on the part of Linear Corporation for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. All implied warranties, including implied warranties for merchantability and implied warranties for fitness, are valid only until Warranty Expiration Date as labeled on the product. This Linear Corporation Warranty is in lieu of all other warranties express or implied. For warranty service on Linear equipment return product, at sender’s expense to:

Linear Hong Kong 19/F Hounor Industrial Centre, 6 Sun Yip StreetChai Wan, Hong Kong Attention: Repairs Department

REPAIRS POLICY

Charges will be made for equipment that is not in warranty, shows customer abuse, or is damaged by the effects of lightning, water, fire, or other abnormal happenings.

Customer’s equipment sent in for repair may be repaired or replaced with new or remanufactured equipment at Linear’s discretion.

The customer is always responsible for shipping and handling charges to the repairs facility. Linear will pay return shipping and handling charges on “in warranty” products shipped back to the customer. The customer will be billed for the return shipping and handling charges on “out of warranty” products.

There will be a 50% expedite fee for any express requests.

The International Sales Manager must be notified prior to the return of product to Linear. All international returns must have an International Repair Authorization number (IRA#). The number must be marked on all packages. Failure to do so will cause delays in processing.

IMPORTANT !!!

	BATTERY TYPE	BE SURE
		BATTERY SPRING
	CR1616, CR1620
		IS IN PLACE
	OR DL1620

R&TTE VAEE 27800, EMC, SFT, ETS

Linear Corporation declares that the apparatus DF-41/EC and DF-42/EC complies with the essential requirements and other relevant provisions of Directive 1995/5/EC.

Linear radio controls provide a reliable communications link and fill an important need in portable wireless signaling. However, there are some limitations which must be observed. The radios are required to comply with local rules and regulations as radio devices. As such, they have limited transmitter power and therefore limited range.

A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies, regardless of code settings.

Changes or modifications to the device may void regulatory compliance. Infrequently used radio links should be tested regularly to protect against undetected interference or fault. A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users.

220101 A