256 AVAILABLE CODES ON EACH SWITCH
You can select any one of 256 codes on Switch “A” and also any one of 256 codes on switch “B”
NOTE:The manufacturer strongly recommends that you test your equipment frequently. From the time of installation, it is absolutely necessary to test the system at least once a week. It is also good practice to change the
NOTE:
The transmitter transmits continuously with button depression. An LED lights during transmission to indicate battery operation.
Left Button "A"
Right Button "B"
Battery
Test Light
This product is warranted to the consumer against defects in material and workmanship for one year from the date of purchase. This warranty applies to first retail buyers of new devices. Warrantor will repair, or at its option, replace, any device it finds that requires service under this warranty, and will return the repaired or replaced device to the consumer at the warrantor’s cost. For warranty service and shipping instructions contact warrantor at the address shown below. Devices must be sent to warrantor for service at owner’s expense. The remedies provided by this warranty are exclusive. Implied warranties under state law are to the one year period of this written warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. In order to be protected by this warranty, save your proof of purchase and send copy with equipment should repair be required. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
All products returned for warranty service require a Return Product Authorization Number (RPM). Contact Linear Technical Services at
Linear radio controls provide a reliable communications link and fill an important need in portable wireless signaling. However, there are some limitations which must be observed.
*For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15 devices. As such, they have limited transmitter power and therefore limited range.
*A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies, regardless of code set- tings.
*Changes or modifications to the device may void FCC compli- ance.
*Infrequently used radio links should be tested regularly to protect against undetected interference or fault.
*A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users.
| Copyright © 1999 Linear Corporation | 207403 G |
Delta-3 Series
DT-2A
Two-button Digital
Transmitter
Code Setting Instructions
(800)