PRODUCT DESCRIPTION

DXS-32/EC

The DXS-32/EC is a battery powered stationary transmitter designed for use with Linear’s DXS and

DX format receivers. This transmitter can be used in a variety of wireless remote control applications.

 

Triggering the transmitter with its built-in magnetic switch sends a digitally coded wireless signal to

 

its companion receiver.

BY

The digital DXS code format features over a million possible codes. The DXS transmitters are

MINIATURE

precoded at the factory to unique codes, so no field coding is required. The DXS-32/EC can send

four different codes: alarm, restore, low battery and status.

 

SUPERVISED

Receivers must be programmed to the transmitter’s code before system testing and operation. Refer

to the receiver’s instructions for details on programming.

DOOR/WINDOW

In a typical installation, the magnet is mounted on a door or window and the transmitter is mounted

on the frame. When the magnet moves more than 1 cm away from the transmitter, an alarm signal

TRANSMITTER

is sent. When the magnet returns next to the unit, a restore signal is sent. The magnet is adjustable

 

 

with four height positions. A 0.5 cm high magnet spacer is also supplied to snap on to the base of

 

the magnet.
Installation Instructions

The transmitter is powered from two 3-Volt #2032 lithium batteries with an expected battery life of

up to 4 years. Every hour, the DXS-32/EC will send a status transmission to the receiver. The hourly

 

signal updates the receiver to the transmitter’s condition. By monitoring status transmissions, the

 

receiver can determine if a transmitter has a low battery or has been removed from the system. DXS

 

format receivers can monitor status signals, DX format receivers cannot.

 

Normally, the transmitter sends an exit/entry delay transmission code. Cutting an internal jumper

 

selects an instant transmission code. Cutting this jumper doesn’t change the time of the actual

 

transmissions, but changes the code of the signal sent so the receiver can determine the transmitter’s

 

function.

(760)438-7000 FAX (760) 438-7043 www.linearcorp.com

DXS-32/EC FEATURES & ACCESSORIES

MAGNET

ALIGNMENT

OPENING CASE
REMOVE THE CASE TOP BY TWISTING A

TRANSMITTER

MARKS

MAGNET

SIDE

MARK

SMALL FLAT BLADE SCREWDRIVER INTHE SLOT ON EITHER END OF THE TRANSMITTER

 

MAGNET

 

ALIGNMENT

TRANSMITTER

MARKS

SCREWS AND

 

DOUBLE STICK TAPE

 

 

MAGNET CAN BE MOUNTED UP TO

 

1 cm FROM LEFT SIDE OF

 

TRANSMITTER

ADJUSTABLE

 

MAGNET

MAGNET

 

 

ADJUSTMENT

 

TAB (EACH SIDE)

MAGNET

 

SCREWS AND

SQUEEZE MAGNET TABS TO

DOUBLE STICK TAPE

ADJUST MAGNET HEIGHT (4 POSITIONS)

REMOVE BATTERY PROTECTION STRIP
TWIST
COMPONENT LOCATIONS
ANTENNA
TWO TYPE 2032 BATTERIES
PULL OUT & DISCARD

 

BATTERY PROTECTION

 

STRIP TO ACTIVATE
DELAY/INSTANT JUMPER
TRANSMITTER
(CUT JUMPER FOR INSTANT)