
DXT-41
DXT-42 BY
MINI TRANSMITTERS
MINIMUM OF 2 SECONDS
BATTERY REPLACEMENT STEP 2PRODUCT DESCRIPTION
The
For versatility, any transmitter code can be programmed into any receiver channel. Receivers must be programmed to the transmitter code before system testing and operation. DX Format digital receivers are programmed by “Learning” the preset factory code from the transmitter. Refer to the receiver’s instructions for details on programming.
Each transmitter is powered from two
A detachable
DXT-42 FEATURES
PRESS LEFT BUTTON TO
SEND A CODE ONE
TRANSMISSION
PRESS RIGHT BUTTON
TO SEND A CODE TWO
TRANSMISSION
PRESS BOTH BUTTONS
TO SEND A CODE THREE
TRANSMISSION
PRESS BUTTON(S) FOR AMINIMUM OF 2 SECONDSBATTERY REPLACEMENT STEP 3
TRANSMITTER CONFIGURATIONS
DXT-41
The
DXT-42
The
KEY
RING
BATTERY REPLACEMENT STEP 1
REMOVE TWOCASE SCREWSHOLD CASE TOGETHERAND FLIP OVERCAREFULLYLIFT TOP OFCASE OFFLINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and workmanship for twelve
CAREFULLY |
| |
REMOVE THE | WARNING: | |
CIRCUIT BOARD | ||
HOLD BOARD BY | ||
| ||
| EDGES ONLY |
| BOARD | |
| ALIGNMENT | |
| POSTS | |
| NOTE BATTERY | |
| LOCATIONS | |
BATTERY TYPE |
| |
CR1616, CR1620 |
| |
OR DL1620 | WARNING: DO NOT | |
| INSTALL BATTERIES | |
PLACE FRESH BATTERIES | BACKWARDS, UNIT | |
WILL BE DAMAGED! | ||
ON SPRING IN HOLDER | ||
| ||
| PLUS (+) SIDE UP |
POSTS
SQUEEZECASE TOGETHER, FLIP OVER AND REPLACE SCREWS
CAUTION: DO NOT TOUCH OR ADJUST ANY PARTS ON BOARD
HOOK CASE
HALVESTOGETHER(12)months. The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or liabilities on the part of Linear
Corporation for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. All implied warranties, including implied warranties for merchantability and implied warranties for fitness, are valid only until Warranty Expiration Date as labeled on the product. This Linear Corporation Warranty is in lieu of all other warranties express or implied.
All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at
Linear radio controls provide a reliable communications link and fill an important need in portable wireless signalling. However, there are some limitations which must be observed.
✶ For U.S. installations only: The radios are required to comply with FCC Rules and |
Regulations as Part 15 devices. As such, they have limited transmitter power and |
therefore limited range. |
✶ A receiver cannot respond to more than one transmitted signal at a time and may |
be blocked by radio signals that occur on or near their operating frequencies, |
regardless of code settings. |
✶ Changes or modifications to the device may void FCC compliance. |
✶ Infrequently used radio links should be tested regularly to protect against |
MINUS |
BE SURE |
BATTERY SPRING |
IS IN PLACE |
This device complies with FCC Part 15. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
undetected interference or fault. |
✶ A general knowledge of radio and its vagaries should be gained prior to acting as |
a wholesale distributor or dealer, and these facts should be communicated to the |
ultimate users. |
Copyright © 2001 Linear Corporation | 211704 B |