|
| DESCRIPTION |
| PROGRAM RECEIVER & TEST TRANSMITTER | ||
| The | Refer to the instructions provided with the receiver to set it into | ||||
| designed for use with automatic garage and gate operators. | “learn” mode. With the receiver ready to learn, press the desired | ||||
| Each of the three transmitter buttons will send a unique code when | transmitter button to | program that button into the receiver’s | |||
| memory. Repeat to program additional buttons for other receivers. | |||||
| pressed. One button can be used to activate the individual’s garage | ||||||
| TRANSMITTER'S THREE BUTTONS CAN BE | ||||||
| door opener, a second button can operate an access gate, a third | ||||||
|
|
|
| THE CODE SENT FROM ANY OF THE |
| |
| button can activate an additional garage door operator or most | LEARNED BY A RECEIVER |
| |||
Linear 318 MHz MegaCode® wireless receivers. |
|
| ||||
DIGITAL | MegaCode® transmitters and receivers do not contain a typical | CHOOSE ONE BUTTON ON |
| |||
TRANSMITTER | “coding switch”. Each transmitter is permanently coded at the | THE TRANSMITTER TO | TO PROGRAM THE CODE, WITH THE RECEIVER | |||
| CONTROL THE SPECIFIC | IN LEARN MODE, PRESS THE TRANSMITTER BUTTON | |||||
| factory. The receiver is programmed by “learning” a transmitter’s | OPERATOR OR RECEIVER | TO SEND A SIGNAL TO THE RECEIVER | |||
Operation | unique | digital code. The receiver will | activate only from the | After programming, test the transmitter from various locations. Be | ||
“memorized” transmitters. |
| sure the door or gate areas are clear. Activate the transmitter | ||||
Instructions |
| |||||
| The transmitter is powered by two Type 2032 | and verify that the receiver triggers the operator(s). | |||||
| They should last 3 years with normal use. The red indicator on the |
| BE SURE THE DOOR OR | |||
| face of the transmitter will glow when the unit is activated. If the |
| GATE AREA IS CLEAR! | |||
|
|
| ||||
| indicator lights dimly, or not at all when transmitting, the batteries | ACTIVATE THE TRANSMTTER |
| |||
| need to be replaced.To conserve battery life, an internal timer limits | TO TEST THE RECEIVER |
| |||
(760) | AND OPERATOR |
| ||||
| the transmission duration to 10 seconds if a transmitter button is |
|
| ||||
| USA & Canada (800) |
|
| ||||
| Toll Free FAX (800) | held down. |
|
|
| ||
| www.linearcorp.com |
|
|
|
|
| |
VISOR CLIP INSTALLATION |
| REPLACING THE BATTERY | LINEAR LIMITED WARRANTY | |||
|
| 1 TWIST DIME IN SLOT | 2 | This product is warranted to the consumer against defects in material and workmanship for one year from | ||
|
| the date of purchase. This warranty applies to first retail buyers of new devices. Warrantor will repair, or at | ||||
|
| TO OPEN CASE | LIFT OFF | its option, replace, any device it finds that requires service under this warranty, and will return the repaired | ||
|
|
| ||||
|
|
| or replaced device to the consumer at the warrantor’s cost. For warranty service and shipping instructions | |||
|
|
| THE TOP OF | |||
|
|
| contact warrantor at the address shown below. Devices must be sent to warrantor for service at owner’s | |||
|
|
| THE CASE | |||
|
|
| expense. The remedies provided by this warranty are exclusive. Implied warranties under state law are to | |||
|
|
|
| |||
|
|
|
| the one year period of this written warranty. Some states do not allow limitations on how long an implied | ||
|
|
|
| warranty lasts, so the above limitation may not apply to you. In order to be protected by this warranty, save | ||
| THE VISOR CLIP CAN |
|
|
| your proof of purchase and send copy with equipment should repair be required. This warranty gives you | ||
|
|
| specific legal rights, and you may also have other rights which vary from state to state. | |||
| BE INSTALLED FOR |
|
|
| |||
|
|
| All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact | |||
| HORIZONTAL OR |
| NOTE: THE CIRCUIT BOARD WILL FIT ONLY ONE | ||||
| Linear Technical Services at | |||||
| VERTICAL MOUNTING | 3 | WAY INTO THE CASE. ALIGN THE PLASTIC POST | ||||
|
| |||||
|
| IN THE CASE WITH THE HOLE IN THE CIRCUIT BOARD |
| IMPORTANT !!! | ||
| CAREFULLY |
|
| |||
| SLIDE THE VISOR CLIP INTO ONE | REMOVE THE | 5 | Linear radio controls provide a reliable communications link and fill an important need in portable wireless | |||
| OF THE SLOTS ON THE REAR | CIRCUIT BOARD | INSERT TWO NEW | signaling. However, there are some limitations which must be observed. | |||
|
| • For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15 | ||||
| OF THE TRANSMITTER |
|
| ||||
|
| TYPE 2032 BATTERIES | devices. As such, they have limited transmitter power and therefore limited range. | |||
|
|
| ||||
|
|
| PLUS SIDE UP THEN | |||
|
|
| • A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio | |||
|
|
| REASSEMBLE UNIT | signals that occur on or near their operating frequencies, regardless of code settings. | ||
|
|
|
| • Changes or modifications to the device may void FCC compliance. | ||
|
|
|
| • Infrequently used radio links should be tested regularly to protect against undetected interference or | ||
|
|
|
| fault. |
| |
|
|
|
| • A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor | ||
|
|
|
| or dealer, and these facts should be communicated to the ultimate users. | ||
| 4 |
|
| • This device complies with FCC Part 15 and Industry Canada Rules and Regulations. Operation is subject | ||
|
|
| to the following two conditions: (1) This device may not cause harmful interference, and (2) this device | |||
| REMOVE OLD BATTERIES |
| must accept any interference received, including interference that may cause undesired operation. | |||
| AND DISPOSE OF THEM PROPERLY |
| Copyright © 2004 Linear LLC | 222267 A | ||
|
|
|
| |||