Wireless-G Broadband Router with 2 Phone Ports
20 Chapter 5: Configuring the Router
The Setup Tab - Basic Setup
Router IP
The values for the Router’s Local IP Address and Subnet Mask are shown here. In most cases, keeping the
default values will work.
Local IP Address. The default value is 192.168.15.1.
Subnet Mask. The default value is 255.255.255.0.
Network Address Server Settings (DHCP)
These settings allow you to configure the Router’s Dynamic Host Configuration Protocol (DHCP) server function.
The Router can be used as a DHCP server for your network. A DHCP server automatically assigns an IP address
to each computer on your network. Unless you already have one, it is highly recommended that you leave the
Router enabled as a DHCP server.
Local DHCP Server. DHCP is enabled by factory default. If you already have a DHCP server on your network, set
the Router’s DHCP option to Disable. If you disable DHCP, remember to assign a static IP address to the Router.
Start IP Address. Enter a value for the DHCP server to start with when issuing IP addresses. Because the
default IP address for the Router is 192.168.15.1, the Start IP Address must be 192.168.15. 101 or greater, but
smaller than 192.168.15.254. The default Start IP Address is 192.168.15.100.
Number of Address (Optional). Enter the maximum number of PCs that you want the DHCP server to assign IP
addresses to. This number cannot be greater than 253. The default is 50.
DHCP Address Range. The range of DHCP addresses is displayed here.