8
Installing or removing the wool bonnet
(optional accessory)
Mount the rubber pad onto the spindle. Screw the lock nut
onto the spindle.
To tighten the lock nut, hold the spindle with the wrench so
that it cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
Fit the wool bonnet completely over the rubber pad and pull
the string tight. Tie a bow knot and tuck the knot and any
loose strings between the wool bonnet and the rubber pad.
To remove the wool bonnet, follow the installation procedure
in reverse.
OPERATION
Sanding operation
CAUTION:
•Always wear safety goggles or a face shield during
operation.
•Never switch on the tool when it is in contact with the
workpiece, it may cause an injury to operator.
•Never run the tool without the abrasive disc. You may
seriously damage the pad.
Hold the tool firmly. Turn the tool on and then apply the abra-
sive disc to the workpiece.
In general, keep the abrasive disc at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result in
poor performance and premature wear to abrasive disc.
1. Wool bonnet
2. Lock nut
3. Rubber pad
1
2
3
003461
003463
15
003472