
27
6. Cutting repetitive lengths
When cutting several pieces of stock to the same length,
ranging from 220 mm (8-5/8”) to 365 mm (14-3/8”), use
of the set plate (optional accessory) will facilitate more
efficient operation. Install the set plate on the holder
(optional accessory) as shown in the figure.
Align the cutting line on your workpiece with either the
left or right side of the groove in the kerf board, and while
holding the workpiece from moving, move the set plate
flush against the end of the workpiece. Then secure the
set plate with the screw. When the set plate is not used,
loosen the screw and turn the set plate out of the way.
NOTE:
•Use of the holder-rod assembly (optional accessory)
allows cutting repetitive lengths up to 2,200 mm (7.2 ft.)
approximately.
Carrying tool
Make sure that the battery cartridge is removed. Secure the
blade at 0° bevel angle and the turn base at right miter angle
fully. Lower the handle fully and lock it in the lowered position
by pushing in the stopper pin.
Carry the tool by carrying grip as shown in the figure. If you
remove the holders, dust bag, etc., you can carry the tool
more easily.
CAUTION:
•Always secure all moving portions before carrying the
tool.
•Stopper pin is for carrying and storage purposes only
and not for any cutting operations.
MAINTENANCE CAUTION:
•Always be sure that the tool is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
1. Set plate
2. Holder
3. Screw
1
2
3
001846
1. Stopper pin
1
001847
001814