5
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed adjusting dial
For BO5041 only
1
010744
The tool speed can be infinitely adjusted between 4,000
and 12,000 orbit per minute by turning the adjusting dial.
Higher speed is obtained when the dial is turned in the
direction of number 5; lower speed is obtained when it is
turned in the direction of number 1.
Refer to the figure for the relationship between the number
settings on the adjusting dial and the kind of work.
A range: For polishing
B range: For finish sanding
C range: For regular sanding
123
Dial setting
Orbits per minute
4000
12000
45
A
B
C
003291
NOTE:
• The figure shows standard applications. They may
differ under certain conditions.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
How to use the front grip
010809
The front grip can be loosened and moved horizontally to
a desired working position. Once the front grip is in the
desired position, retighten before using.
Installing or removing the front grip
1
2
010805
Open the grip base, and attach it to the sander in the
area of the Makita logo.
1
2
010804
After closing the grip base, firmly tighten on the front grip
to the screw section of the grip base.
010806
To remove, loosen and remove front grip, and then
remove grip base.
Installing or removing abrasive disc
010745
To install the abrasive disc, first remove all dirt or foreign
matter from the pad. Then peel off the backing paper
from the abrasive disc and attach the abrasive disc to the
1. Grip base
2. Makita logo
1. Screw
2. Front grip
1. Speed adjusting
dial