Makita LS0711Z OPERATION

The holders and the holder assembly can be installed on

either side as a convenient means of supporting workpieces

horizontally. Install them as shown in the figure. Then tighten

the screws firmly to secure the holders and the holder

assembly.

When cutting long workpieces, use the holder-rod assembly

(optional accessory). It consists of two holder assemblies

and two rods 12.

CAUTION:

•Always support long workpieces level with the top

surface of the turn base for accurate cuts and to prevent

dangerous loss of control of the tool.

OPERATION CAUTION:

•Before use, be sure to release the handle from the

lowered position by pulling the stopper pin.

•Make sure the blade is not contacting the workpiece, etc.

before the switch is turned on.

•Do not apply excessive pressure on the handle when

cutting. Too much force may result in overload of the

motor and/or decreased cutting efficiency. Push down

handle with only as much force as is necessary for

smooth cutting and without significant decrease in blade

speed.

•Gently press down the handle to perform the cut. If the

handle is pressed down with force or if lateral force is

applied, the blade will vibrate and leave a mark (saw

mark) in the workpiece and the precision of the cut will

be impaired.

•During a slide cut, gently push the carriage toward the

guide fence without stopping. If the carriage movement

is stopped during the cut, a mark will be left in the

workpiece and the precision of the cut will be impaired.

1. Holder

2. Holder assembly

002247

1. Holder assembly

2. Rod 12

002246