11
Hose connector assembly
Use the hose connector assembly to connect to water
source. It consists of the following parts.
C00099
Assemble the above parts hand tight as follows.
1. Attach the hose connector to the outlet of water cock.
2. Tighten the connector firmly to the hose. Insert the con-
nector to the hose connector as far as it will go.
3. Tighten the hose connector to the end of the hose.
4. Fit the hose connector to the port on the tool.
OPERATION
Polishing operation
WARNING:
•To reduce the risk of electric shock, check the tool's
water supply system to ensure there is no damage to the
seals (“O” rings) or hoses. A damaged water supply
system may result in abnormal water flow to the tool
which could be dangerous.
CAUTION:
•Always wear safety goggles or a face shield during
operation.
•Never switch on the tool when it is in contact with the
workpiece, it may cause an injury to operator.
•Never run the tool without the abrasive disc. You may
seriously damage the pad.
Make sure that the cock is closed. Connect the hose to the
tool. Make sure that water comes out when the water lever is
opened.
Hold the tool firmly. Turn the tool on and then apply the abra-
sive disc to the workpiece.
Apply slight pressure only. Excessive pressure will result in
poor performance and premature wear to abrasive disc.
1. Water cock
2. Hose connector
3. Connector
4. Hose
1
2
3
4
2
004736
Part name Description
Hose Connecter 1/2” pipe thread
Connecter 1/2”mail pipe thread
Hose 5/8”in inner diameter × 25’ in length
006102
006103