2.When lighting your fire, a little smoke may escape into the room – more likely if the chim- ney is cold. To correct this, hold a lighted newspaper up inside the firebox near the open flue damper. This will turn around any down- draft and clear the flue of cold air. As your log fire burns below, the updraft will improve as the chimney heats up.

3.Is your fire too far forward? Move it toward the back with your poker. Keep the fire well within the confines of your fuel grate.

4.Keep your fire up on the grate and the refrac- tory below free of excessive ashes. The fire needs plenty of air movement around the logs.

5.If smoking occurs an hour or two after lighting the fire, perhaps your well-insulated house is too airtight and there is scarcely any way for replacement air to enter and feed the fire. Check to see if your outside combustion air kit (if installed) is open. Check outside to ensure no obstructions are in front of exterior air entry. Open a window slightly, open doors to one or two rooms and see if this stops the smoking.

6.Is a vent fan, exhaust hood or central heating/cooling system stealing combustion air from your fireplace? If their volume is high enough, this can cause negative pressure and an unwanted downdraft – and smoking.

7.Is your wood fuel too wet or unseasoned? Or does it contain some chemical substance that causes sputtering, smoking and toxic fumes?

8.Figure 9 illustrates the correct height of your chimney top. It is unlikely that your instal- lation does not adhere to the installation instructions. However, if not correct, you could experience an unusual downdraft. Usu- ally, the best solution is to increase the chimney height. This may also be necessary if nearby trees, adjoining roof lines or a hill is causing a downdraft condition.

9.Remember, your fireplace has been de- signed as a supplemental heating device only, it is not intended to heat your entire home.

REPLACEMENT PARTS

A complete parts list is found at the end of this manual. Use only parts supplied from the manufacturer.

Normally, all parts should be ordered through your Lennox dealer. Parts will be shipped at prevailing prices at time of order.

When ordering repair parts, always give the following information:

1.The model number of the appliance.

2.The serial number of the appliance.

3.The part number.

4.The description of the part.

5.The quantity required.

6.The installation date of the appliance.

ACCESSORY COMPONENTS

Less Than 10' (1 m)

 

 

 

 

2'

 

 

 

 

(51 mm)

 

2'

 

 

Min.

 

 

3'

 

(51 mm)

 

(914 mm)

 

 

Min.

3'

Min.

 

10' (1 m)

 

 

 

(914 mm)

 

 

 

 

Min.

Figure 9

WARRANTY

This fireplace is covered by a limited warranty detailed separately from this document.

Retain this manual. File it with your other documents for future reference.

PRODUCT REFERENCE INFORMATION

We recommend that you record the following important information about your fireplace. Please contact your Lennox dealer for any questions or concerns. For the number of your nearest Lennox dealer, please call 1-800-9-LENNOX

Your Fireplace's Model Number _______________________________________

Your Fireplace's Serial Number ________________________________________

The Date On Which Your Fireplace Was Installed __________________________

Your Dealer's Name _________________________________________________

8

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Forced Air Kit

LFAK-2000

Blower Kit

The LFAK-2000 blower provides for a constant velocity forced air circulation feature for your appliance.

Louver Kits

 

 

38" Brass

91L63

38LK-B

43" Brass

91L64

43LK-B

Louver Kits

Decorative louver kits are available to enhance and beautify the front face of your fireplace. These kits are designed to attach directly to the fireplace front face over the standard louvers. They are available in an attractive bright brass finish.