Image Projection (Continued)

GEOMETRIC ADJUSTMENT

Info

•When adjusting a 4:3-aspect-ratio input sig- nal to a 4:3-aspect-ratio screen, correct the trapezoidal distortion by setting “ASPECT” to “FULL” (16:9).

1Press cKEYSTONE on the remote control repeatedly until “GEOMET- RIC ADJUSTMENT” is displayed.

ROn-screen display

Adjust upper left corner

GEOMETRIC ADJUSTMENT

ADJUST RESET

NEXT END

2

Adjust the focus, size, and projec-

 

tion angle so that the screen

 

edges line up into the blue area.

 

• Line up the screen edges into the blue

 

area as closely as possible.

3 Press P, R, Oor Qto move the position for the upper left of the im- age.

•Adjust the screen until the displayed red arrows line up in the upper left.

Blue

Geometric Adjustment

area

Screen Upper Left Upper Right

 

4

5

Press iENTER to set the position.

• The arrow in the upper right turns red.

Lower Left

Lower Right

Repeat the same procedure with the positions for the upper right, lower right and lower left of the image.

•When you press eRETURN at this point, you will return to the previous screen.

•If you press eRETURN before adjusting the upper left corner, the Reset Confir- mation screen displays.

•When you confirm the lower left posi- tion, the screen adjustments will be set and the “GEOMETRIC ADJUSTMENT” mode will end.

Note

•The placement of the screen and the projector may result in the image aspect ratio becoming slightly distorted.

•Try “H&V KEYSTONE” when “GEOMETRIC ADJUSTMENT” does not fully correct trapezoi- dal distortion.

34