Troubleshooting Procedures (Electronic Models)
Trouble 4: Oven operates with little or no heat.
Output
performance is low.
Check the power supply voltage.
Lower than 90% of rated voltage.
Normal
Decrease in
supply voltage under load.
Customer must contact local
power
company or
qualified electrician.
Disconnect wire leads from relay RY2 and
verify on and off times.
Measure the output power.
Abnormal
Normal
Abnormal
Failed controller.
Failed magnetron
Replace controller.
Replace magnetron.
NOTE: Simple test of power output can be conducted by heating one liter of water for one minute. Refer to Power Test on page 24 of this manual.
©2004 Maytag Services | 16023293 Rev. 0 | 15 |