APPENDIX A: ASSEMBLING ARRAYS WITH THE MTG-1100 TOP GRID
32
■Lower the suspended loudspeakers so the bottom cabinet is approximately 1 inch above the top cabinet on the floor.
Adjust the placement of the stack on the floor so the top cabinet’s rigging bars align with those of the suspended cabinet
above it. Extend the GuideALinks from the top cabinet into the slots of the suspended cabinet above it. Don’t worry if
you can’t yet pin the GuideALinks to the suspended cabinet. First pin the GuideALinks in the top cabinet on the floor, in
the extended position, with the 1/2 x 1.25-inch quick-release pins (blue) included with the 1100-LFC.
■Lower the suspended loudspeakers just enough so the GuideALinks from the top cabinet on the floor can be linked to
the suspended cabinet. Pin the GuideALinks from the top cabinet on the floor to the suspended cabinet with the 1/2 x
1.25-inch quick-release pins (blue) included with the 1100-LFC.
■Make sure the GuideALinks for the other loudspeakers in the stack on the floor are securely pinned.
■Attach the AC power, audio, and RMS cables to the loudspeaker stack on the floor.
■Raise the grid so the loudspeakers are suspended slightly off the floor and remove the two rear quick-release pins secur-
ing the caster frame to the bottom cabinet. Rest the rear wheels of the caster frame on the floor and remove the two front
quick-release pins to detach the caster frame from the bottom cabinet. Return the four quick-release pins to the bottom
cabinet.
■Raise the grid so the suspended loudspeakers are slightly higher than the next stack of 1100-LFCs to be linked. Roll
away the empty caster frame.
■Repeat the previous steps until the entire array has been assembled. All loudspeaker-to-loudspeaker links should be
secured with the 1/2 x 1.25-inch quick-release pins (blue) included with 1100-LFC.
CAUTION: Do not lift an 1100-LFC stack until all four GuideALinks have been pinned for each cabinet. Failing
to do so could damage the rigging bars or GuideALinks for the linked units.
!