Leveling the dryer | Miele T 7644 C specs

Installation and connection

Leveling the dryer

To ensure trouble-free operation, the dryer must be level.

Compensate for floor irregularities by turning the threaded feet in or out.

Do not block the gap between the bottom of the tumble dryer and the floor with plinth facings, deep pile carpet etc. This would hinder a sufficient flow of air to the dryer.

The air inlet/outlet vents on the front and back must NEVER be covered. Otherwise, sufficient condenser cooling cannot be ensured.

38

Image 38

Miele T 7644 C operating instructions Leveling the dryer

Contents

Operating Instructions For condenser tumble dryer T 7644 C Disposing of your old appliance Caring for the environmentDisposal of packing material Saving energy Contents Contents Important Safety Instructions This dryer is intended for residential use only Grounding Instructions Accessories Operating the dryer Dear Customer Main FeaturesDescription Function of Miele condenser dryer To do all this, the dryer is equipped with systems Laundry care anti-crease action and roll-up prevention Control panel Fault indicator / Optical interfaceOperating the dryer Display Programmable functions DelayProgram duration/ Estimated time remaining Drying tips Care symbolsLaundry care Drying Laundry care Preparing the laundry Proper dryingBrief instructions Turn on the dryer Dryness level selection in programs Extra options/Select DelaySelect program End of program Remove laundry Starting the programBefore the end of a program Gentle Options/DelayDelay Buzzer Hand iron, Rotary iron Program OverviewNormal Extra dry, Normal Wrinkle-free Extra dry, Normal, Hand iron Express Normal, Hand iron WoolensSmoothing Dress shirts Normal, Hand iron Timed cold Timed warm Loading or removing laundry Switching over from a running programChanging the program sequence Time remaining Deactivating the lock Electronic lockActivating the lock Cleaning and care Emptying the condensed water container Cleaning the lint filtration components Cleaning without water Cleaning the dryer Cleaning with water Cleaning the condenser heat exchanger unit Removing the condenser unit Checking the condenser unit Replacing the condenser unit Handle of the unit must be on top, the locking lever down What to do, if . . . ? Trouble shootingTest and fault messages Canceling the fault Problem Cause SolutionCanceling test Container indicator light Other problems Dryer after Problem Cause Solution Water runs fromCleaned Condenser has been Cold programs will not Start and the indicatorWhen switched on Lights for these programs Replacing the light bulb Warranty conditions and warranty period Customer serviceProgram updates Optional accessories Installation and connection Front view Washer-dryer stack Rear view Installation siteCarrying the dryer to the installation site Leveling the dryer Ventilating the installation area Before transport at a later date Arranging the drain hose Draining condensed water externallyGeneral Special installation conditions requiring a non-return valve Hooking up the drain hose in sink or floor drain Installation and connection Electrical connections Technical data Programmable functions for changing Standard values Programmable functions Extending the range of drying levels For programming and saving in memory, follow steps to Adjusting buzzer volumeBuzzer normal default setting Buzzer loud Memory No Memory default settingSet memory function Extending cooldown time Default setting Change function of Filter/Vent indication Adjust keypad tone No Keypad tone default setting Keypad tone on Important condition Changing water conductivity settingDefault setting Lower conductivity setting Page Page Page Alteration rights reserved Nr 323 260