Milan Technology MIL-185C, MIL-195C

Installation Guide MIL-185C/MIL-195C

MIL-195C

The MIL-195C converter supports full-duplex ATM

Fiber/UTP links. For fiber budget constraints, the MIL-

195C has a launch power of -19 db and a receive

sensitivity of -30 db (using a 1300 nm class 1 laser). In a

full-duplex environment, up to 100m of CAT 5 UTP and

15km single-mode fiber can be used.

Figure 4. MIL-195C

Specifications

Storage Temperature

• Minimum: -25° C

• Maximum: 75° C

Installation

To install either converter:

1. Attach the CAT 5 UTP cable from the network to the

RJ-45 port on the device.

Note: Use screened CAT 5 UTP cable for CISPR-22 class B installation.

2. Attach the fiber network cable connectors to the

connectors marked “RX” (Receive) and “TX”

(Transmit).

3. Connect the power receptacle from the wall adapter

to the unit.

4. Verify that the power LED illuminates.

5. Verify that both the UTP and the FIBER active LEDs

also illuminate when all cables are attached.

Important notice: This device is set to half duplex mode at the factory. If you are

experiencing excessive collision errors or CRC errors, then you

must force full duplex mode operation on the connecting

device(s) before you power up the MiLAN device(s).

Diagnostic LEDs

• UTP ACTIVE: Illuminates when the device receives a

valid signal from the device connected to the UTP port

• POWER: This LED illuminates when the device is

powered up

• FIBER ACTIVE: Illuminates when the device receives a

valid signal from the device connected to the fiber port.

UTP ACTIVE

5VDC

FCC PART 15 CLASS A COMPLIANT

RXTX

ATM Twist

Model: MIL 195 

UTP

Fiber

ATM

Single-Mode

CONVERTER

POWER

FIBER ACTIVE

UTP ACTIVE