Mitek H615C Mtx Warranty Information, Installation Preparation- New Construction, Step

MTX WARRANTY INFORMATION

All MTX In-Ceiling Speakers purchased in the United States from an authorized MTX dealer are guaranteed against defects in material and workmanship for a period ten years from the date purchased by the end user, and limited to the original retail purchaser of the product. Product found to be defective during that period will be repaired or replaced by MTX at no charge. This warranty is void if it is determined that unauthorized parties have attempted repairs or alterations of any nature. Warranty does not extend to cosmetics or finish. Before presuming a defect is present in the product, be certain that all related equipment and wiring is functioning properly. MTX disclaims any liability for other incurred damages resulting from product defects. Any expenses incurred in the removal and reinstallation of product is not covered by this warranty. MTX's total liability will not exceed the purchase price of the product. If a defect is present, your authorized MTX dealer may be able to effect repairs.

Proof of purchase is required when requesting service, so please retain your sales receipt and take a moment to register your product on line at www.mtx.com.

INSTALLATION PREPARATION- NEW CONSTRUCTION

When installing the H515C or H615C into a newly built ceiling, please follow these instructions carefully.

1) Determine placement

Determine the location in the ceiling the speakers will be placed, using the recommendations in the "Loudspeaker Placement" section.

2) Mount a Rough-In Kit

For best results, mount a RIK5C Rough-In Kit for H515C or RIK6C for H615C from Mitek Corp.(available at your MTX dealer). Follow the instructions included with the kit.

3) The location is ready for drywall

The RIK5C or RIK6C bracket provides a stable opening around which the drywall installer can cut out an opening, providing a perfect location for the installation of the H515C or H615C.

INSTALLATION

STEP 1

Using a stud finder (available at low cost at most hardware stores) or other accurate method, locate cen- ter point between two joists and mark. Using template provided, trace hole pattern on surface of ceiling

STEP 2

Using a sabre saw, keyhole saw or very sharp utility knife, cut hole in wall, following traced pattern.

STEP 3

Run loudspeaker wires to sound source location. There are several methods you can use to accomplish wiring, depending on the construction characteristics of the room or house. You can add a professional touch to your installation by using a speaker terminal plate at the source location. Leave sufficient amount of wire at speaker location (8 to 10 inches) to complete connection.

STEP 4

Attach loudspeaker wires to speaker terminals, observing correct polarity, and position speaker frame up into cutout. Be careful not to pinch wires in the process.