211
Communication operation and setting
4
PARAMETERS
4.19.2 Wiring and arrangement of RS-485 terminals
(1) RS-485 terminal layout
(2) Connection of RS-485 terminals and wires
Loosen the terminal screw and insert the cable into the terminal.
Name Description
RDA1
(RXD1+) Inverter receive+
RDB1
(RXD1-) Inverter receive-
RDA2
(RXD2+)
Inverter receive+
(for branch)
RDB2
(RXD2-)
Inverter receive-
(for branch)
SDA1
(TXD1+) Inverter send+
SDB1
(TXD1-) Inverter send-
SDA2
(TXD2+)
Inverter send+
(for branch)
SDB2
(TXD2-)
Inverter send-
(for branch)
P5S
(VCC)
5V
Permissible load current 100mA
SG
(GND)
Ground
(connected to terminal SD)
Screw size M2 Wire the stripped cable after twisting it to prevent it from
becoming loose. In addition, do not solder it.
Use a blade terminal as necessary.
Tightening
torque 0.22N•m to 0.25N•m
Cable size 0.3mm 2 to 0.75mm2
Screwdriver Small flathead screwdriver
(Tip thickness: 0.4mm /tip width: 2.5mm)
CAUTION
Undertightening can cause signal loss or malfunction. Overtighte ning can cause a short circuit or malfunction due to damage to
the screw or unit.
REMARKS
Information on blade terminals
Blade terminals available on the market: (as of March 2008)
zPhoenix Contact Co.,Ltd.
zNICHIFU Co.,Ltd.
Use shielded or twisted cables for connection to the control c ircuit terminals and run them away from the main and powe r circuits
(including the 200V relay sequence circuit).
When using the blade terminal (without insulation sleeve), use care so that the stranded w ires do not come out.
RXD
RDA1
(RXD1+)
RDB1
(RXD1-)
RDA2
(RXD2+)
RDB2
(RXD2-)
SDA1
(TXD1+)
SDB1
(TXD1-)
SDA2
(TXD2+)
SDB2
(TXD2-)
P5S
(VCC)
SG
(GND)
P5S
(VCC)
SG
(GND)
VCC
TXD
OPEN
100Ω
Terminating resistor switch
Factory-set to "OPEN".
Set only the terminating resistor switch of
the remotest inverter to the "100Ω" position.
5mm
(0.2inches)
Terminal Screw
Size Wire Size (mm2)Blade Terminal Model Blade terminal
crimping tool
with insulation sleeve without insulation sleeve
M2 0.3, 0.5 AI 0,5-6WH A 0,5-6 CRIMPFOX ZA3
Terminal Screw
Size Wire Size (mm2)Blade terminal product
number
Insulation product
number
Blade terminal
crimping tool
M2 0.3 to 0.75 BT 0.75-7 VC 0.75 NH 67