42
FX3G/FX3U/FX3UC Series Programmable Controllers
Programming Manual - Basic & Applied Instruction Edition
2 Overview (Sequence Program)
2.7 Types and Setting of Parameters
2.7.2 Parameter initial values and available tools for changing parameter values
1) FX3U/FX3UC PLC
*1. These programming tools are not applicable to FX3U/FX3UC PLCs. The initial values in FX2N PLCs are shown
above.
*2. Parameter values can be changed only by the F940WGOT, F94GOT and F94 handy GOT.
*3. Only manuals in Japanese are available for the ET-940 Series.
*4. The initial value is 8000 steps in GX Developer Ver.8.13P to Ver.8.22Y.
*5. GX Developer Ver.8.23Z or later is applicable.
*6. This item is supported only in the FX3UC-32MT-LT-2, and can be set using GX Developer Ver. 8.68W or later.
Item GX Developer
Initial value
Setting
range
Programming tool Display unit
FX-30P
FX-10P
(-E)*1
FX-20P
(-E)*1
FX-PCS/
WIN(-E)*1
GOT
1000
GOT-F900
Series*2
ET-940
Series*3
Memory
capacity
(steps)
Program capacity 16000*4
Refer to
Subsection
2.7.3.
8000 2000 8000 16000 8000
Katakana character
comment capacity 0 000––
File register capacity 0 00000
Special unit initial
value setting*5 Not used – – – – –
Positioning setting*5 Not used – – – – –
Built-in CC-Link/LT
Setup*6 Not used – – – – –
Latch
range
(battery
backed)
Auxiliary relay [M] 500 to 1023 0 to 1023 500 to 1023
State relay [S] 500 to 999 0 to 999 500 to 999
Counter [C] (16 bits) 100 to 199 0 to 199 100 to 199
Counter [C] (32 bits) 220 to 255 200 to 255 220 to 255
Data register [D] 200 to 511 0 to 511 200 to 511
Program title Not registered
Refer to
Subsection
2.7.1.
––
Not
registered ––
Entry code Not registered Not
registered
Not
registered
Not
registered ––
Batteryless mode OFF No – OFF – –
Modem initialization specification Not set NONE – Not set – –
RUN terminal input OFF INVALID Not used Not used
(X0) OFF –
Serial port operation setting Not set No – Not set – –