5 - 14
5. PARAMETERS
5.2 Interface unit
5.2.1 IFU parameter write inhibit
POINT
Use the unit operation section pushbutton switches or MR Configurator
(servo configuration software) to set the IFU parameters of the interface
unit.
Use the unit pushbutton switches or MR Configurator (servo configuration software) to set the interface
unit parameters.
When assigning the devices, change the setting to "000E".
The following table indicates the IFU parameters which are made valid for reference and write by setting
the IFU parameter No. 19.
Setting Setting
operation IFU basic parameter
Expansion
IFU
parameter
I/O
assignment
Reference
0000
(initial
value) Write
Reference IFU parameter No. 19
000A Write IFU parameter No. 19
Reference
000B Write
Reference
000C Write
Reference
000E Write
Reference
100B Write IFU parameter No. 19
Reference
100C Write IFU parameter No. 19
5.2.2 Lists
POINT
For any parameter whose symbol is preceded by *, set the IFU parameter
value and switch power off once, then switch it on again to make that
parameter setting valid.