Mitsubishi Electronics MR-J2S- CP

5 - 1

5. PARAMETERS

CAUTION Never adjust or change th e parameter values extremely as it will mak e operation

instable.

5.1 Parameter list

5.1.1 Parameter write inhibit

POINT

Set "000E" when using the MR Configurator (servo configu ration

software) to make device setting.

After setting the parameter No.19 value, switch power off, then on to

make that setting valid.

In the servo amplifier, its parameters are classified into the basic parameters (No.0 to 19), expansion

parameters 1 (No.20 to 53), expansion parameters 2 (No.54 to 77) and special parameters (No.78 to 90)

according to their safety aspects and frequencies of use. In the factory setting condition, the customer can

change the basic parameter values but cannot chan ge the expansion parameter 1,2 values and special

parameter values. When fine adjustment, e.g. gain adjustment, is required, change the parameter No.19

setting to make the expansion par ameters write-enabled.

The following table lists the parameters whose values are made valid for reference/write by setting

parameter No. 19. Operation can be performed for the parameters marked .

Parameter No.19

setting Operation Basic parameters

No.0 to No.19

Expansion parameters 1

No.20 to No.53

Expansion parameters 2

No.54 to No.77

special parameters (No.78 to 90)

Reference 0000

(initial value) Write

Reference No.19 only

000A Write No.19 only

Reference

000B Write

Reference

000C Write

Reference

000E Write