7 - 1
7. DISPLAY AND OPERATION
7. DISPLAY AND OPERATION
7.1 Display flowchart
Use the display (5-digit, 7-segment LED) on the front panel of the servo amplifier for status display,
parameter setting, etc. Set the param eters before operation, diagnose an alarm, confirm external
sequences, and/or confirm the operation status. Press the "MODE" "UP" or "DOWN" button once to move
to the next screen. Refer to sec tion 7.2 and later for the description of the corresponding display mode.
To refer to or set the expansio n parameters 1, expansion parameters 2 and special parameters, make
them valid with parameter No.19 (parameter write disable).
Display mode transition In itial screen Function Reference
Servo status display.
appears at power-on.
Section 7.2
Alarm display, external signal display, output
signal (DO) forced output, test operation,
software version display, VC automatic offset,
motor series ID display, motor type ID display,
encoder ID display
Section 7.3
Current alarm display, alarm history display,
parameter error No. display, poin t table error
No. display.
Section 7.4
Display and setting of point table data.
Section 7.5
Display and setting of basic parameters.
Display and setting of expansion parameters 1.
Display and setting of expansion parameters 2.
button
Status display
Diagnosis
Alarm
Point table
Basic parameter
Expansion parameter 1
Expansion parameter 2
Special parameter
MODE
Display and setting of special parameters.
Section 7.6