40 Chapter 3. NetCommand Setup and Editing
NetCommand® Initial Setup
The initial setup screens that appear when you first power
on your new Mitsubishi TV guide you through setup of
NetCommand and the TV Guide On Screen® system.
Most IR remote control signal formats can be learned by
NetCommand.
Welcome Screen
Figure 1
When you first turn on your TV, the NetCommand
Welcome screen displays and asks you to select either
English or Spanish as the language for the on-screen
menus. The default language is English. To change
Language later, select Setup in the Main Menu. Selecting
Cancel at this screen will cause the default languag e
(English) to be selected.
Figure 1. Welcome screen
NetCommand (Information) Screen
Figure 2
The NetCommand (Information) Screen describes how
to start or delay the initial NetCommand and TV Gui de
On Screen setup. This screen displays automatically the
first time you power On your new TV, after the Welcome
screen.
Figure 2. Information screen
Select Next> and press ENTER to start the ini tial setup.
If the NetCommand Setup is cancelled before it’s
completed, you can restart the NetCommand setup from
the Setup Reminder screen (see page 42) or by doing the
following:
1. Press TV MENU on the remote control to display the
TV Main menu.
2. Select NetCommand. The available options will be
Add, Review, Guide or Initial. Change and Delete will
be grayed out.
3. Press ADJUST to select Initial.
4. Press ENTER. The Device Setup screen (shown on
the next page) displays.
IMPORTANT
You may use your TV without setti ng up
NetCommand or the TV Gu ide On Screen®
system. To set up at a later time, choose th e
NetCommand menu from the M ain menu,
then select Initial. Th e TV Guide On Screen
system is set up from the NetCo mmand
menu.