Chapter 2: Device Installation

15 foot power cable assembly

The Network Operator must supply the following:

Mounting Location

Power Source (12V DC) (from vehicle or other DC power supply)

A Hub or Switch (if more then 1 Ethernet device will be used)

Hand tools for bracket installation

MAC Address Label Location

The transceiver and SBC (Ethernet) MAC addresses for the VMM6300 and for the VMM7300 are listed on the label located either on the front side or on the back of the VMM unit. Record these numbers in the MAC Address Tables provided in the next section.

The figure below is only a sample VMM label, an actual device label for either of the VMM devices will be designated accordingly.

Figure 2-1 VMM Sample Device Label

6881011Y54-A September 2005

2-2