CHANNEL SCAN

The 8-channel, GM300 mobile may have a single-user scan list which can be programmed from the front panel.

To turn scan on or off

Press the SCAN () button. The radio will only scan when the microphone is on-hook.

The green scan LED will turn on, and display segments will light to indicate that scan is func- tional. Use the SELECT button to advance through the various scan types:

User Scan

Priority User Scan

When an active channel is detected, the channel number will be displayed and you will hear the call. To leave scan, press the SCAN () button.

To respond to scanned channel activity

When the microphone is lifted off-hook, the radio will suspend scanning and return to the channel displayed before entering scan. If you wish to transmit on another channel, press the UP/DOWN ( / ) button to reach the desired channel. Scan will resume after replacing the microphone on-hook.

When scanning with priority, the green scan LED will flash to indicate activity on Priority One and light steady for Priority Two.

To delete a nuisance channel

While receiving an undesired transmission, hold down the SELECT ( + ) button for two seconds and the nuisance channel will be temporarily deleted (until scan is exited or the radio is turned off). Priority channels and the home channel cannot be deleted.

To create or modify the user list

Hold the SCAN () button for two seconds until you hear a second chirp tone and the channel number flashes. The displayed channel can be added or deleted from the user list by pressing the SELECT ( + ) button.

A vertical segment in the upper left corner of the display will light and flash, alternating with the channel number to indicate that the flashing channel has been added to the scan list. The segment will disappear when the channel is deleted.

Use the UP/DOWN ( / ) and SELECT ( + ) buttons to add or delete other desired channels in the user list.

To select priorities for the user list

Go to the desired channel and hold the SELECT ( + ) button down for two seconds. The scan LED will flash to indicate that this is the first priority channel. Repeat the process to select a second priority channel. Priority Two will be indicated by a steady light on the scan LED.

The Priority-One channel must be programmed first, followed by the Priority-Two channel. Deleting either of the priority channels will delete both channels simultaneously.

© 1997 by Motorola, Inc. 8000 West Sunrise Blvd. Ft. Lauderdale, FL 33322

, Motorola, MaxTrac, PL, and DPL

Printed in U.S.A.

are trademarks of Motorola, Inc.

All Rights Reserved.