IMPORTANT: RESETTING AUTO BREW AT THE PRE-SET TIME
The programmable timer will not automatically brew the next day if left in the “AUTO” position after its last use. This is a safety feature. If the “OFF” indicator light in the lower right hand corner of the clock display is illuminated, reset “AUTO BREW” by turning the control switch to “OFF”, then to “AUTO.” (Models NLX20, NLX23, NLX20D, NLX23D, NLX26 Only)
SETTING CLOCK AND TIMER
(NLX30, NLX33)
NOTE: You do not have to set your clock before the Coffeemaker will operate. Plug in the power cord, press SELECT once to turn the Coffeemaker on. The “ON” light will illuminate and the clock will stop flashing, but it will not keep time.
SETTING THE CLOCK
1. Plug the power cord into your electrical outlet. The clock display will flash until you set the time.
2. Alternately press and hold the “HOUR” and “MINUTE” buttons until you reach the current time.
3. The “PM” indicator light in the display will illuminate to indicate PM time.
PRESETTING THE BREWING TIME
1. You must first set the clock to the correct time before setting the Auto brew.
2. Press the PRESS/HOLD button, then alternately press the HOUR and MINUTE buttons to set the time you want the Coffeemaker
to start brewing. The Auto indicator light will flash during this time.
3. Press the PRESS/HOLD button again to turn off the flashing light.
If the Auto light is not flashing, pressing the HOUR or MINUTE buttons will change the clock time.
BREWING AUTOMATICALLY AT THE PRESET TIME
1. Follow Steps 1 – 5 in the “Brewing” Section.
2. Press the PRESS/HOLD button. The “AUTO” indicator light should illuminate.
3. Brewing will begin at the preset time. The coffee will remain hot in
the decanter for 2 hours. To keep your coffee hot for an additional 2 hours, press the “SELECT” button. The “ON” indicator light should illuminate.
5
