2.Align the holes in the chute base with the holes in the lower chute and secure with the previously removed hex washer screws. See Fig. 3-4.

Figure 3-4

Installing the Recoil Starter Handle

On some models it may be necessary to install the recoil starter handle. If your handle is not pre-installed follow the directions below to install it.

1.Remove the eye bolt and handle knob from the manual bag.

2.Place the eye bolt and handle knob on the upper handle as shown in Fig. 3-7. Do not fully tighten the hardware until instructed to do so.

Eye Bolt

Recoil Starter

Handle

A Handle

Knob

B

Figure 3-7

NOTE: The opening of the eye bolt should face toward the back of the snow thrower.

3.Slowly pull the recoil starter handle up towards the eye bolt.

4.Slip the recoil starter rope into the eye bolt from the back of the snow thrower. See Fig. 3-7.

5.Securely tighten the eye bolt and handle knob.

Set-Up

Adding Oil

Refer to the Engine Operator’s Manual packed with your snow thrower for information on adding and checking oil.

Adding Fuel

Refer to the Engine Operator’s Manual packed with your snow thrower for information on adding fuel.

8Section 3— Assembly & Set-Up