3.The rope guide is attached to the right side of the upper handle. See Fig. 3-3. Loosen the wing nut which secures the rope guide.

A

B

D

C

Figure 3-3

a.Hold blade control against upper handle.

b.Pull starter rope out of the engine. Release blade control.

c.Slip starter rope into rope guide.

d.Tighten wing nut.

4.Insert post on cable tie into hole provided on the lower handle. Pull cable tie tight and trim excess. See Fig. 3-4.

Figure 3-4

Grass Catcher

1.Follow steps below to assemble the grass catcher. Make certain bag is turned right side out before assembling (warning label will be on the outside).

a.Place bag over frame so that its black plastic side is at the bottom.

b.Slip plastic channel of grass bag over hooks on the frame. See Fig. 3-5. All the plastic channels except center top of bag attach from outside of bag.

A

C

B

Figure 3-5

c.Attach center top of bag from inside of bag.

Section 3 — Assembly & Set-Up