MAINTENANCE AND REPAIR INSTRUCTIONS

Line Installation

This section covers both SplitLine™ and standard single line installation.

Always use original equipment manufacturer 0.105 in. (2.67

mm)replacement line. Using line other than the specified may make the engine overheat or fail.

WARNING: Never use metal-reinforced line, wire, chain or rope. These can break off and become dangerous projectiles.

There are two methods to replace the trimming line:

•Wind the inner reel with new line

•Install a prewound inner reel

Winding the Existing Inner Reel

1.Hold the outer spool with one hand and unscrew the Bump Knob clockwise (Fig. 12). Inspect the bolt inside the Bump Knob to make sure it moves freely. Replace the Bump Knob if damaged.

2.Remove the inner reel from the outer spool (Fig. 12).

3.Remove spring from the inner reel (Fig. 12).

4.Use a clean cloth to clean the the inner reel, spring, shaft, and inner surface of the outer spool.

5.Check the indexing teeth on the inner reel and outer spool for wear (Fig. 13). If necessary, remove burrs or replace the reel and spool.

Outer Spool

Spring

Inner Reel

Bump Knob

Bolt

Fig. 12

Indexing Teeth

NOTE: SplitLine™ can only be used with the inner reel with the slotted holes. Single line can be used on either type of inner reel. Use figure 15 to identify the inner reel you have.

NOTE: Always use the correct line length when installing trimming line on the unit. The line may not release properly if the line is too long.

SplitLine™ Installation

6.Take approximately 10 feet (3 m) of new trimming line. Insert one end of the line through one of the two holes in the inner reel (Fig. 15). Pull the line through the inner reel until only about 4 inches is left out.

Slotted Holes

Fig. 14

7.Insert the end of the line into the open hole in the inner reel and pull the line tight to make the loop as small as possible (Fig. 16).

8.Before winding, split the line back about 6 inches.

Loop

Fig. 15

Fig. 13

6