3.Press inward on tab on the engine baffle to release it from the baffle bracket. See Fig. 7-3.

Figure 7-3

4.Slide belt off of engine pulley and thread through the opening in the deck. See Figure 7-4.

Figure 7-4

NOTE: When removing belt on units with a 25mm adapter, the pulleys and washers may also break free from the crankshaft. Be sure to make note of the orientation of these items for reassembly.

5.Replace with new belt, making sure belt is firmly seated on engine pulley while pulling from the other side and sliding it around the transmission pulley.

6.Reattach engine baffle and reassemble blade as described in the previous section.

7.Turn mower back over and make sure belt is seated on the transmission pulley. Pivot the belt keeper wire back into its operating position and snap into the slot provided.

8.Reassemble front drive cover.

Off-Season Storage

The following steps should be taken to prepare your lawn mower for storage.

•Clean and lubricate mower thoroughly as described in the lubrication instructions.

•Do not use a pressure washer or garden hose to clean your unit.

•Coat mower’s cutting blade with chassis grease to prevent rusting.

•Refer to engine manual for correct engine storage instructions.

•Store mower in a dry, clean area. Do not store next to corrosive materials, such as fertilizer.

When storing any type of power equipment in a poorly ventilated or metal storage shed, care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the equipment, especially cables and all moving parts of your lawn mower before storage.

Section 7 — Service

 

17