3.The rope guide is attached to the right side of the upper handle. See Fig. 3-3. Loosen the wing nut which secures the rope guide.

b.Slip plastic channel of grass bag over hooks on the frame. See Fig. 3-4. All the plastic channels except center top of bag attach from outside of bag.

 

A

 

 

 

A

 

B

 

 

D

C

 

 

C

 

B

Figure 3-3

a.Hold blade control against upper handle.

b.Pull starter rope out of the engine. Release blade control.

c.Slip starter rope into rope guide.

d.Tighten wing nut.

4.Insert post on cable tie into hole provided on the lower handle. Pull cable tie tight and trim excess.

Grass Catcher

1.Follow steps below to assemble the grass catcher. Make certain bag is turned right side out before assembling (warning label will be on the outside).

a.Place bag over frame so that its black plastic side is at the bottom.

Figure 3-4

c.Attach center top of bag from inside of bag.

2.Follow the steps below to attach the grass catcher:

a.Lift rear discharge door. See Fig. 3-5.

B

A

Figure 3-5

b.Place grass catcher on the pivot rod. Let go of discharge door so that it rests on the grass catcher.

WARNING: Never operate mower unless the hooks on the grass catcher are firmly seated on the pivot rod and the rear discharge door rests firmly against top of the grass catcher.

Section 3 — Assembly & Set-Up