Multiquip MC3PE, MC3SE, MC3S (B&S) MIX N GO Mixer Basic Engine, Engine Controls and Components

MIX N' GO MIXER — BASIC ENGINE

Figure 5. Engine Controls and Components

INITIAL SERVICING

The engine (Figure 5) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers engine manual for instructions and details of operation and servicing.The engine shown above is a Briggs and Stratton engine, operation for other types of engines may vary somewhat.

1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

DANGER

Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT

attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

2.	Fuel Tank – Holds unleaded gasoline. For additional
	information refer to engine owner's manual.
3.	Recoil Starter (pull rope) – Manual-starting method. Pull
	the starter grip until resistance is felt, then pull briskly and
	smoothly.
4.	Oil Drain Plug – Remove this plug to remove oil from the
	engine's crankcase.
5.	Dipstick/Oil Filler Cap – Remove this cap to determine if
	the engine oil is low. Add oil through this filler port as
	recommended in Table 4.

6. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).

7.Choke Lever – Used in the starting of a cold engine, or in cold weather conditions. The choke enriches the fuel mixture.

Operating the engine without an air

filter, with a damaged air filter, or a

NOTEfilter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

8.Air Cleaner – Prevents dirt and other debris from entering the fuel system. Remove wing-nut on top of air filter cannister to gain access to filter element.

9. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.024 - 0.028 inch) Clean spark plug once a week.

10. Muffler - Used to reduce noise and emissions.

WARNING

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.

PAGE 18 —MIX N' GO MIXER — OPERATION & PARTS MANUAL — REV. #5 (1/07/05)