The following information is
applicable only where local
ordinance permits use of your alarm
Control Center for fire detection

Controrlklg

Your

Fin

Circuit
If your alarm specialist installed
smoke detectors or heat sensing
thermostats, you have 24 hour fire
protection. This optional Fire Pro-
tection Zone is always active, even
though your system may be dis-
armed. An optional Fire Supervision
and Indicator Station on the Control
Center provides the following fire
circuit controls.

ACFOWWCtWCk

If the yellow AC light on the Fire
Supervision and Indicator Station is
off, the Control Center is not receiv-
ing AC power. Press the spring-
loaded SILENCE
8.
FIRE RESET
switch toshut off the Mini-Sounder.
Check lights to see if there is a
general power outage. If there is,
you will be operating from your
standby battery. When AC power is
restored, the Mini-Sounder will
come back on. Press the spring-
loaded switch again to silence the
Mini-Sounder.

Fire-zone

check

The Mini-Sounder on the Fire
Supervision and Indicator Station
signals a problem on the Fire Zone.
Press the spring-loaded SILENCE
8 FIRE
RESETswitch
toshutoff the
Mini-Sounder. The red TROUBLE
light will come on until the Fire
Zone is cleared. When the zone is
restored, the Mini-Sounder will
signal again to indicate that the
Fire Zone is functional. Press the
SILENCE 8 FIRE RESET switch
once again to turn off the
Mini-
Sounder.

Fire--Reset

After a fire alarm, the red FIRE
ALARM light will be on. Press the
SILENCE 8 FIRE RESET switch to
clear the smoke detectors.
Alann/BaRtefyTese
The fire alarm bell/siren and
standby battery should be tested
weekly. Disarm the Control Center.
Push the BATTERY
a
BELL TEST
switch down and listen to the bell/
siren. If the alarm sounds weak,
the battery is faulty. Call for service.

Would You

Uke

More

sawylnformatlon?

For information on home fire de-
tection, burn safety, and home fire
safety, contact the National Fire
Protection Association, Public
Affairs Dept.O5A, Battetymarch
Plaza,
Quincy,
MA 02269.
NOTE: If there is no Fire Supervision and Indicator Station on your Control
Center and your Fire Zone uses smoke detectors, have your alarm specialist
show you and explain the switch he has installed for resetting the smoke
detectors after an alarm.
13