Chapter 2 Installation and Configuration
© National Instruments Corporation 2-11 NI PXIe-8130 User Manual
In addition, if a USB mass storage device is present, the following option
is available:
•USB Mass Storage Device Configuration—Use this setting to access
the USB Mass Storage Device Configuration submenu. Refer to the
next section, USB Mass Storage Device Configuration Submenu, for
more information. If no USB Mass Storage Device is detected, then
this setting will not be present.
–USB Mass Storage Device Configuration Submenu—Use this
submenu to apply alternate settings to USB mass storage devices.
Normally, you do not need to modify these settings, as the factory
default settings provide the most compatible and optimal
configuration.
•USB Mass Storage Reset Delay—This setting specifies the
number of seconds the Power-On Self Test will wait for a
USB mass storage device to start. The default is 20 seconds.
•Emulation Type—This setting specifies how the BIOS will
present the USB mass storage device to the system. This
option can be used to present a USB mass storage device as a
floppy, Zip, hard disk, or CD-ROM drive. The default is
Auto, which allows the BIOS to treat USB devices under
530 MB as floppy drives and all other devices as hard disk
drives.
Event Log Configuration Submenu
Use this submenu to access the system event log. The event log can be used
to detect errors that occur during the Power-On Self Test.
•View Event Log—Use this option to view all unread events in the
system event log.
•Mark all events as read—Use this option to mark all events in the
system event log as read.
•Clear Event Log—Use this option to discard all events in the system
event log.