© National Instruments Corporation A-1 PXI-8461 or PXI-8460 and NI-CAN for Windows NT
A

Uninstalling the Hardware

and Software

This appendix describes how to uninstall the PXI-8461 or PXI-8460
hardware and the NI-CAN software from WindowsNT.

Uninstalling the Hardware from Windows NT

Because WindowsNT 3.51 and 4.0 do not maintain hardware information
for the board, you just need to physically remove your PXI hardware from
your computer. To do so, shut down WindowsNT, power off your PXI or
CompactPCI chassis, remove any cables attached to your board, and
physically remove the board.

Uninstalling the NI-CAN Software from Windows NT

Note The following instructions apply to Windows NT 4.0 only. If you are using Windows
NT 3.51, refer to the readme.txt file in your NI-CAN directory forinformation on how
to uninstall the NI-CAN software.
Before uninstalling the NI-CAN software, you should remove the PXI
boards from your computer, as explained in the previous section.