E-3
Part Names of the Projector
1. INTRODUCTION
CONTROL
COMPONENT IN
COMPUTER IN
VIDEO IN
AUDIO IN
S-VIDEO IN
R
Cr/Pr
Cb/Pb
Y
L/mono
AUDIO IN
SELECT
LAMP
STATUS
POWER
ON/STAND BY
AUTO
ADJ.
AC IN
LENS SHIFT
UP
SELECT
LAMP
STATUS
POWER
ON/STAND BY
AUTO
ADJ.
SOURCE
* This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of
Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.
Remote Sensor (See page E-9)
Controls (See page E-4)
Speaker
Ventilation (outlet)
Terminal Panel
(See page E-5)
AC Input
Connect the supplied power
cable's two-pin plug here, and
plug the other end into an ac-
tive wall outlet. (See page E-20)
Main Power Switch
When you plug the supplied power cable into an active wall outlet
and turn on the Main Power, the POWER indicator turns orange and
the projector is in standby mode. (See page E-21)
Ventilation (inlet)
Adjustable Tilt Foot
(See page E-25)
Adjustable Tilt
Foot Lever
(See page E-25)
Lens Cap
Lens
Focus ring
(See page E-26)
Zoom lever
(See page E-25)
Lamp Cover
(See page E-46)
Lens Shift Dial
(down/up)
(See page E-15)
Lamp Cover Screw
(See page E-46)
Ventilation (inlet)
Built-in Security Slot ( ) *
Adjustable Rear Foot
(See page E-24)