NEC MT1056 - page 22

E – 22
Connecting Your DVD Player
M
E
N
U
E
N
T
E
R
C
A
N
C
E
L
SELECT
POWER
STATUS
ON
/
STAND BY
SOURCEAUTO ADJUST
AC IN
S-VIDEO
VIDEO
AUDIORGB INPUT 2
AUDIORGB INPUT 1
L
/
MONOR
AUDIORGB MONITOR
OUTPUT
USBPC-CARD
C CONTROLMOUSE
OUT
REMO
CONTR
INPU
S-VIDEO
VIDEO
AUDIO RGB INPUT 2
AUDIO RGB INPUT 1
L
/
MONO R
AUDIO RGB MONITOR
OUTPUT
RGB INPUT
R L
Y Cb Cr
R L
AUDIO Component
AUDIO
You can connect your projector to a DVD player with component outputs or Video output. To do so, simply:
1.Turn off the power to your projector and DVD player.
2.If your DVD player has the component video (Y/Cb/Cr) output, use a commercially available component video cable (RCA3) and the optional
15-pin-to-RCA (female)3 cable to connect your DVD player to the RGB INPUT connector on the projector.
For a DVD player without component video (Y/Cb/Cr) outputs, use common RCA cables (not provided) to connect a composite VIDEO output of
the DVD player to the Video Input of the projector.
3.Turn on the projector and DVD player.
NOTE: Refer to your DVD player’s owner’s manual for more information about your DVD player’s video output requirements,
Optional 15-pin-to-RCA (female)3
cable (ADP-CV1)
Audio cable
(not supplied)
DVD player
White
Red
Y
Cb
Cr
White
Red
Audio Equipment
Component video cable
RCA3 (not supplied)