ii
Important Information
RF Interference (for U SA only)
WARNING
The Federal Communications Commission d oes not allow any modi cations or changes to the unit EXCEPT
those speci ed by NEC Corporation of America in this manual. Failure to comply with this government regula-
tion could void your right to operate this equipment. Th is equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These lim its are designed to pro-
vide reasonable protection against harmful interferen ce in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not insta lled and used in accordance with the instruct ions,
may cause harmful interference to radio communication s. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radi o or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to tr y to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and rece iver.
• Connect the equipment into an outlet on a circuit dif ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio / T V technician for help.
For UK only: In UK, a BS approved power cable with moulded plug has a Bl ack ( ve Amps) fuse installed for use
with this equipment. If a power cable is not supplied wi th this equipment please contact your supplier.
Important Safeguards
These safety instructions are to ensure the long life of your projec tor and to prevent re and shock. Please read
them carefully and heed all warnings.
Installation
• Do not place the projector in the following condition s:
- on an unstable cart, stand, or table.
- near water, baths, or damp rooms.
- in direct sunlight, near heaters, or heat radiating applian ces.
- in a dusty, smoky or steamy environment.
- on a sheet of paper or cloth, rugs or carpets.
• If you wish to have the projector installed on the ceiling:
- Do not attempt to install the projector yourself.
- The projector must be installed by quali ed technicians in order to ensure proper operation and reduce the
risk of bodily injury.
- In addition, the ceiling must be strong enough to suppor t the projector and the installation must be in accor-
dance with any local building codes.
- Please consult your dealer for more information.
10˚
Place the projector in a horizo ntal position
The tilt angle of the projector should not exceed 10 degrees, nor should the pr ojector be installed in any way other
than the desktop and ceiling mount, other wise lamp life could decrease dramatically.