CHAPTER 6 16-BIT TIMER 20
User’s Manual U15331EJ4V1UD 115
6.4.2 Operation as timer output
16-bit timer 20 can invert the timer output repeatedly each time the free-running counter value reaches the value
set to CR20. Since this counter is not cleared and holds the count even after the timer output is inverted, the interval
time is equal to one cycle of the count clock set in TCL201 and TCL200.
To operate 16-bit timer 20 as a timer output, the following settings are required.
• Set P33 to output mode (PM33 = 0).
• Reset the output latch of P33 to 0.
• Set the count value in CR20.
• Set 16-bit timer mode control register 20 (TMC20) as shown in Figure 6-6.
Figure 6-6. Settings of 16-Bit Timer Mode Control Register 20 for Timer Output Operation
−0/1 0/1 0/1 1 0/1 0/1 1
TOD20 TOF20
CPT201 CPT200
TOC20
TCL201 TCL200
TOE20
TMC20
Setting of count clock (see Table 6-2)
Inverse enable of timer output data
TO20 output enable
Caution If both the CPT201 flag and CPT200 flag are set to 0, the capture edge operation is prohibited.
When the count value of 16-bit timer counter 20 (TM20) matches the value set in CR20, the output status of the
TO20 pin is inverted. This enables timer output. At that time, TM20 continues counting and an interrupt request
signal (INTTM20) is generated.
Figure 6-7 shows the timing of timer output (see Table 6-2 for the interval time of 16-bit timer 20).
Figure 6-7. Timer Output Timing
CR20
INTTM20
TOF20
NN N NN
t
0000H N
FFFFH
N
0000H 0001H0001H
TO20
Note
Count clock
TM20 count value
Interrupt
acknowledgement
Interrupt
acknowledgement
Overflow flag set
Note The initial value of TO20 becomes low level when output is enabled (TOE20 = 1).
Remark N = 0000H to FFFFH